Instructions / Assembly

GLD Products Pockey 3 in 1 Table

Item 64-1046

11 1-800-225-7593

www.gldproducts.com

STEP 5 - ATTACH THE TABLE TOP

NOTE: The end of the table top with the power cord has the three 3/4" washers (#14) and

two 3/4" hex nuts (#15) pre-assembled on the power cord.

It is possible that the support axle bolts are not pushed out completely. To pull them

out, thread a nut onto the end and pull outward with pliers. If the bolt does not pull

out freely, tap it with a hammer to break it loose, then pull.

1. Open all four of the table locks.

WARNING: Dropping the table or resting all of the table weight on one or two of closed table

locks is likely to break the lock mechanism.

2. Place one 3/4" washer (#14) over the support axle. Thread the 3/4" hex nut (#15) onto

the axle followed by another washer (#14).

3. Lift the table top into position over the side supports.

4. Lower the table top so the supporting axles drop into the slots in the pedestals.

NOTE: The two washers and the nut should be placed to the inside of the pedestals.

5. Place another washer (#14) and thread a nut (#15) onto the support axle.

6. Release all of the table locks. Tighten the nuts on the support axle to provide smooth

table top rotation.

#14

#15

Open the

Table Locks