User manual
Fat Shark 5 RC Vision Systems
Headset Operation
Controls
Brightness/contrast control: pressing left and right increases/decreases display contrast. Press
forward/back increases/decreases brightness.
Display mode selection: Goggles will boot up in 2D analog. Vertical press of the contrast/brightness
button scrolls through the following modes: Analog 2D/3D/ HDMI 2D/3D.
Channel select: Pressing channel up/down buttons will cause the channel to incrementally
increase/decrease from channels 1 to 8 (see relevant receiver module for channel map). Audio
beep on channel change. A long beep sounds on channel top and bottom limits.
Low battery warning: Audio warning if input voltage drops below 6.8V
Volume control: each press of button increments volume up or down.
Head tracker: (refer to documentation included with module purchase)
RX power switch: The RX module power is independently controlled via this switch. If a module
is inserted, but desired video source is via the AV cable; the RX module needs to be turned off
to avoid image conict.
DVR control: Connect AV cable to AV out port on right side of headset. Connect recording device
to cables and set up as per manufacturer directions.
DVR Operation
Note:
1. SD card MUST be formatted before use to ensure stable recording.
2. DVR is for analog recording only, no HD recording.
3. Do not place alternative les that you want to keep into the DVR. The DVR may not
recognize the le space and write over your les. Use dedicated SD card.
Recording:
After powering goggles, turn on DVR by depressing vertically and holding the DVR control
button for 1 full second (long press).
ED LED should now show solid.
Ensure SD card is inserted and short press to start recording (RED LED will slowly FLASH
(~2 times/second).
Short press again stops recording (turns to solid RED LED).
Playback
Note: requires turning off external receiver and removing any other AVin sources (to not
conict with menu navigation OSD).
After turning on DVR and in stop record mode (SOLDID RED LED) depress and hold DVR
button for 1 second (long press) to enter menu.
Menu Navigation
Playback (press right to enter)
Now can see: Preview shot with le number
press up/down to change le number
Press right to play
Up/down controls playback speed/direction
Right press pause/play
Left press, back to main menu
Format (press right to enter)
Execute (press right)
Pressing left from main menu exits menu