User Manual

Fat Shark Specification Document

Model Numbers: FSV1258

Model Name: 1G3 Ground Camera

Document Revision/Date: Rev A / 11.24.2016

This 1G3 Ground Camera is fully enclosed with

splash proof case for run with RC ground vehicles.

Software Function:

Channel Selection by PWM:

Stay on last frequency selected on power cycle

if there is no PWM signal present;

Startup in PWM mode, but when power is on at

the beginning 3~5 seconds, if CPU cannot detect

any PWM signal, then auto transfer to button

selection mode;

Before channel changes, there is a 200ms delay

seeing a constant pulse at a given value;

If the pulse width falls into the dead band

between channels it should be no change of

frequency. For failsafe operation, there should

be no change at 1550μs +/-75μs.

When CPU detects PWM signal at 1550μs +/-75μs,

then auto transfer to button selection mode;

Channel Selection by Button:

Solid Red Power LED (bottom) for indicating

power on, Green Channel LED (top) flashes on

channel change, Green Channel LED is solid

on channel 1 only.

PAGE 1
Fat Shark Specification Document Model Numbers:FSV1258 Model Name:1G3 Ground Camera Document Revision/Date:Rev A / 11.24.2016 This 1G3 Ground Camera is fully enclosed with splash proof case for run with RC ground vehicles.
PAGE 2
Optical: Imager: 1/3” 700TVL CMOS Waterproof Backup Lens: 2.2 mm (IR cut) System: Analog NTSC Electrical: Output Power: 25mW Working Voltage: 3.9-6V Button Control: Connector: Single push button to switch channel (1 to 8 then back to CH1) 100mm long silicone cable, 3p 2.