Fat Shark 1 RC Vision Systems TELEPORTER V5 FPV HEADSET USER MANUAL Revision A 03/17/2016 For more product information, please visit: www.fatshark.
Fat Shark 2 RC Vision Systems Contents Product contents ................................................................................................................... 3 Controls Diagram .................................................................................................................. 4 Controls ................................................................................................................................. 4 Head Tracking Menu Navigation...............................
Fat Shark Product contents Carry case Teleporter Headset 5G8 Antenna (TX, RX) Battery (and discharge lead) Lens cloth Manual 3 RC Vision Systems
Fat Shark 4 RC Vision Systems Controls Diagram Antenna SMA Channel Control Power in AV in/out Head Tracker Data Port (Analog) Volume Control Display Control/ Head Tracker Control Receiver on/off (Power to RX Module) Earphone Jack Controls Display control: pressing left and right increases/decreases display contrast. Press forward/back increases/decreases brightness.
Fat Shark 5 RC Vision Systems Head Tracker control: Long Press: Activate/deactivate digital head tracking. Depressing display control button (long press, vertical axis) toggles head tracker mode. On power up is normal (no zoom) and the display will show entire camera image. On HT digital mode, the image will zoom in and image will digitally pan and tilt in response to head motion. Short Press: resets center reference position (both analog/digital). Note analog head tracking output is always on.
Fat Shark 6 AV in/out Port RC Vision Systems Ground Video AudR AuL RCA Connector: Yellow: Video, White: Audio Left, Red: Audio Right Recording Video Connect AV cable to AV out port on right side of headset. Connect recording device to cables and set up as per manufacturer directions. Note: Cables pins are not all the same (see above chart), be sure to connect to headset using the included cable. Using an external receiver: Use the AV cable to connect headset to the RCA AV port of external devices.
Fat Shark 7 RC Vision Systems General Lithium Polymer safety and handling instructions: • NEVER leave a LiPo battery unattended while being charged or discharged. • ALWAYS monitor the battery and charger during the entire charging process. • ALWAYS charge LiPo batteries in a fireproof location. • ALWAYS have a lithium approved “class D type” fire extinguisher available. • NEVER charge LiPo batteries at currents greater than the “1C” rating of the battery (“C” equals the rated capacity of the battery).
Fat Shark 8 RC Vision Systems WARNING: DO NOT POWER TRANSMITTER WITHOUT ANTENNA ATTACHED. NO ANTENNA LOAD WILL DESTROY RF AMPLIFIER – NOT COVERED BY WARRANTY Small white connector on back of transmitter is for ImmersionRC Tiny Telemetry. See accessories. 700TVL CMOS on pan / tilt 3.6mm lens for wide angle 97 degree FOV; ideal for pan/tilt camera piloting. Camera is NTSC/PAL selectable (NTSC default, remove jumper on back for PAL). Plugs camera directly into TX via included cable (pre assembled).
Fat Shark 9 Specifications Headset Specifications Optics: FOV 25 degrees diagonal Interpupillary (IPD) distance: 63.5mm (fixed) Optional diopter lens inserts available in -2, -4, -6 dpt Audio: Stereo User Controls: Channel selection Contrast/brightness Head tracker reset Volume adjustment Electrical: Power supply, 7-13V (2S/3S supply) Power consumption: 200/350mA (direct/wireless) Battery: 7.
Fat Shark 10 RC Vision Systems Operational advice For best performance, select a channel that has the least amount of interference. While the transmitter is turned OFF, turn on the video headset and look at the screen as you check each channel. Clear channels will have a consistent static background. Channels with interference will have horizontal static lines.
Fat Shark 11 RC Vision Systems Trouble shooting Observation No image, display is completely dark No image, display is glowing dark grey Static on all channels No image on one channel, static on the rest. Lots of interference lines (horizontal lines) Lots of interference lines (horizontal lines) when using 5.8Ghz receiver Battery DOA Battery won’t charge Short range Short range (con’t) White dots on LCD display Possible cause/solution - No power supplied. Check power connections.
