Instructions / Assembly

A. Keypad does not respond

B. Can not change programming code

C. Can not delete all the existing user

codes at once

1. Check to see if the batteries are properly installed.

2. Check to see if the indicator is flashing. It means "the

battery is low" if the indicator keeps flashing.

3. Make sure the cable is well-connected to the port.

4. Please contact us if such problem could not be solved.

1. Complete the "CHANGE PROGRAMMING CODE" process by

inputting codes within 10 seconds.

2. Make sure you have entered the new programming code

twice correctly or go back to the factory setting (refer to

page 31) again.

3. Please contact us if such problem could not be solved.

1. Make sure all codes are entered within 10 seconds.

2. Make sure you have entered the correct programming code.

3. Cancel button should be pressed and held for 3 seconds at

least.

TROUBLESHOOTING GUIDELINE

SolutionsProblem

1. Make sure all codes are entered within 10 seconds.

2. Make sure you have entered the correct programming code.

3. The new user code will not be accepted if 100 user codes

are already stored in the memory.

D. Cannot add a new user code.