Installation Guide

ManualsBrandsFavorite Monkey ManualsCabinet LightsLED Under Cabinet HardWired Low Profile Puck Light Kit (3-Pack)

This document is intended for reference only, by qualified electricians and should not be considered a substitute for national, state and local electrical codes.

*THIS PRODUCT MUST BE INSTALLED BY A QUALIFIED ELECTRICIAN IN ACCORDANCE WITH THE NEC, STATE AND LOCAL CODES.

*DO NOT USE A FIXTURE IF THE HOUSING, LENS OR POWER CABLES ARE DAMAGED.

*TO AVOID RISK OF AN ELECTRICAL SHOCK, PLEASE SHUT OFF THE MAIN POWER BEFORE INSTALLING AND WIRING THIS UNIT.

*DO NOT ATTEMPT TO OPEN THIS FIXTURE AS IT CONTAINS NO USER SERVICEABLE PARTS.

A. Selecting a Power Supply

For compliant operation, Favorite Monkey fixtures must be operated with a suitable UL listed Class 2 power supply. Please

select a power supply that is compatible with your lighting requirements. The power supply selected can either drive a single

fixture or a series or array of multiple connected fixtures. Proper power supply selection is determined by the wattage of the

fixtures installed and this selection is the sole responsibility of the installer. Do not exceed the wattage limits of the power

supply. The total wattage of the series or string of fixtures is additive and must be lower in value than the power supply rating.

The installer can purchase the power supply from any supplier offering a suitable Class 2 power supply, or through Favorite

Monkey.

B. Installing the Plug in Type Power Supply

1) Identify the location for the power supply.

2) When using a single power supply and multiple fixtures, the fixtures are installed in an array format

using a dimmer switch and a splitter. Install the dimmer switch between the plug in type power supply and splitter.

Splitter is omitted for a single puck installation.

Dimmer

Splitter

Summary of content (2 pages)

PAGE 1
This document is intended for reference only, by qualified electricians and should not be considered a substitute for national, state and local electrical codes. *THIS PRODUCT MUST BE INSTALLED BY A QUALIFIED ELECTRICIAN IN ACCORDANCE WITH THE NEC, STATE AND LOCAL CODES. *DO NOT USE A FIXTURE IF THE HOUSING, LENS OR POWER CABLES ARE DAMAGED. *TO AVOID RISK OF AN ELECTRICAL SHOCK, PLEASE SHUT OFF THE MAIN POWER BEFORE INSTALLING AND WIRING THIS UNIT.
PAGE 2
C. Installing Favorite Monkey POP flat LO fixture D. Installing the Hard Wired Power Supply If you wish to hard wire the power supply direct to the AC mains, have a qualified electrician connect the line voltage to the input side of the power supply in accordance with national, state and local electrical codes using an appropriate junction box (not included). 1) Isolate from the mains supply before installation 2) Wire the LED fixture onto the DC output of the driver using the pigtail.