Installation Guide

ManualsBrandsFavorite Monkey ManualsCabinet LightsPOP Hardwired LED Stainless Steel 3000K Ultra Low Profile Under Cabinet Puck Light Kit (3-Pack)

This document is intended for reference only, by qualified electricians and should not be considered a substitute for national, state and local electrical codes.

*THIS PRODUCT MUST BE INSTALLED BY A QUALIFIED ELECTRICIAN IN ACCORDANCE WITH THE NEC, STATE AND LOCAL CODES.

*DO NOT USE A FIXTURE IF THE HOUSING, LENS OR POWER CABLES ARE DAMAGED.

*TO AVOID RISK OF AN ELECTRICAL SHOCK, PLEASE SHUT OFF THE MAIN POWER BEFORE INSTALLING AND WIRING THIS UNIT.

*DO NOT ATTEMPT TO OPEN THIS FIXTURE AS IT CONTAINS NO USER SERVICEABLE PARTS.

A. Selecting a Power Supply

For compliant operation, Favorite Monkey fixtures must be operated with a suitable UL listed Class 2 power supply. Please

select a power supply that is compatible with your lighting requirements. The power supply selected can either drive a single

fixture or a series or array of multiple connected fixtures. Proper power supply selection is determined by the wattage of the

fixtures installed and this selection is the sole responsibility of the installer. Do not exceed the wattage limits of the power

supply. The total wattage of the series or string of fixtures is additive and must be lower in value than the power supply rating.

The installer can purchase the power supply from any supplier offering a suitable Class 2 power supply, or through Favorite

Monkey.

B. Installing Favorite Monkey POP fixture

Unscrew the top portion from the bottom portion. Use provided screws to affix the bottom portion of puck light to surface

then screw on the top portion to the anchored bottom portion.

Plug all puck lights into splitter then plug pigtail into the end of the splitter and follow instructions for chosen transformer. Note

that if using dimmable transformer there are additional instructions.

Summary of content (2 pages)

PAGE 1
This document is intended for reference only, by qualified electricians and should not be considered a substitute for national, state and local electrical codes. *THIS PRODUCT MUST BE INSTALLED BY A QUALIFIED ELECTRICIAN IN ACCORDANCE WITH THE NEC, STATE AND LOCAL CODES. *DO NOT USE A FIXTURE IF THE HOUSING, LENS OR POWER CABLES ARE DAMAGED. *TO AVOID RISK OF AN ELECTRICAL SHOCK, PLEASE SHUT OFF THE MAIN POWER BEFORE INSTALLING AND WIRING THIS UNIT.
PAGE 2
C. Installing the Hard Wired Power Supply If you wish to hard wire the power supply direct to the AC mains, have a qualified electrician connect the line voltage to the input side of the power supply in accordance with national, state and local electrical codes using an appropriate junction box (not included). 1) Isolate from the mains supply before installation 2) Wire the LED fixture onto the DC output of the driver using the pigtail.