Installation Instructions

Chapter "Using bottom bracket"
52
evation |
18.1 Correct position/alignment
For the drive system to function correctly, the speed sensor and spoke
magnet must be correctly mounted and aligned on the rear wheel.
• The distance between the marking on the speed sensor and the
spoke magnet must be in the range of 0.16–0.59
II
(4-15 mm).

If the distance between speed sensor and spoke magnet
is outside the specified range or the speed sensor is not
correctly connected, the drive system operates in "Soft Fault"
fault mode.
More detailed information can be found → in chapter 22.1 "Status
display" or in chapter 26.1 "Status display".
NOTICE
Risk of damage!
If the spoke magnet and speed sensor are too close to each
other and touch each other, the two parts may be damaged and
may have to be replaced.
► The spoke magnet must be positioned on the spoke so that
it can move freely past the speed sensor at the marking
level.
18.2 Correcting incorrect position/alignment
If you notice that the drive system is in "Soft Fault" fault mode because
the speed sensor and spoke magnet are not correctly aligned, proceed as
follows:
1. Using a screwdriver, carefully loosen the fixing screw on the spoke
magnet.
2. To set the correct distance between the mark on the speed sensor and
the spoke magnet:
• Move the spoke magnet vertically on its spoke (up/down),
if necessary.
• Turn the spoke magnet around its own axis if necessary.