User Manual

3
3
3
3
3
3
3
3
3
3
3
3
3
3
Oil & Gas Wireless Enabled Monitoring System 31
Installer’s Guide
RF Test Menu
The RF Test menu shown in Figure 3-15 below performs a test on the device’s
radio. During the test, the radio broadcasts on specified channel using the settings
in the menu. To select the broadcast channel, choose a channel number from
0 to 52 from the pull-down list. Also, select an Amp Mode from the five options
in the pull down list - Off, Low, Medium, High, Cycle modes. Enter the length
of time in seconds for the test to run in the Duration field Once the correct test
settings are selected, hit the Begin button to perform the test.
Figure 3-15. RF Test Menu for an i CCU.