User Manual

3
3
3
3
3
3
3
3
3
3
3
3
3
3
Oil & Gas Wireless Enabled Monitoring System 33
Installer’s Guide
iCCU-Specific Menus
The iCCU tabs include menus for uplinking the iCCU to a computer and displaying
status information for the iCCU. Figure 3-17 shows the iCCU uplink menu that
is accessed by selecting the Uplink tab, and Figure 3-18 shows the iCCU status
menu that is accessed by selecting the Status tab.
iCCU Uplink Menu
The iCCU uplink menu, shown in Figure 3-17 below, uplinks the iCCU to a
computer which downloads a data set. The Uplink Mode has two options - Modem,
which is the default, and Direct. In Modem mode, the iCCU uplinks to a satellite
which uses the Phone # to dial up the computer. To use the Direct mode, the
iCCU must be hardware-configured to connect directly to the serial port of a
computer using a special cable.
Before beginning an uplink, verify that the current battery charge is above the
preset Uplink Threshold. To begin an uplink, choose the Uplink Mode, enter the
Phone # for the computer, and hit the Set Parameters button. Once the
software accepts the parameters, hit the Uplink NOW! button to send the most
recent data points for each device uplinked to the iCCU.