User Manual

CanDo HD Diagnostic Tablet

NOTE:

This equipment has been tested and found to comply with the limits for

a Class B digital device, pursuant to Part 15 of the FCC Rules.

These limits are designed to provide reasonable protection against

harmful interference in a residential installation.

This equipment generates uses and can radiate radio frequency energy

and, if not installed and used in accordance with the instructions, may

cause harmful interference to radio communications. However, there is no

guarantee that interference will not occur in a particular installation. If this

equipment does cause harmful interference to radio or television reception,

which can be determined by turning the equipment off and on, the user is

encouraged to try to correct the interference by one or more of the

following measures:

1) Reorient or relocate the receiving antenna.

2) Increase the separation between the equipment and receiver.

3) Connect the equipment into an outlet on a circuit different from that

to which the receiver is connected.

4) Consult the dealer or an experienced radio/TV technician for help.

FCC Radiation Exposure Statement

This equipment complies with FCC radiation exposure limits set forth

for an uncontrolled environment. This equipment should be installed and

operated with minimum distances 20cm between the radiator include

antenna & your body.

SAR tests are conducted using

Standard operating positions accepted by the FCC with the HD Pro III

transmitting at its highest certified power level in all tested frequency

bands, although the SAR is determined at the highest certified power level,

the actual SAR level of the phone. While operating can be well below the

maximum value, in general, the closer you are to a Wireless base station

antenna, the lower the power output. Before a new model phone is a