User's Manual

FDT Technologies-http://www.fdt.us
4
Environment
The camera should be kept in a cool, dry place away from direct sunlight, flammable materials,
explosive substances, etc.
This product should be transported, stored, and used only in the specified environments as stated
above.
Do not aim the camera at a strong light source, as it may cause overexposure of the picture, and
may affect the longevity of the camera’s sensors.
Ensure that the camera is in a well ventilated area to prevent overheating.
Operation and Maintenance
Do not touch the camera sensor or lens directly.
To clean dust or dirt off of the lens, use an air blower or a microfiber cloth.
Accessories
Be sure to use only the accessories recommended by manufacturer.
Before installation, please open the package and check to ensure that all of the components are
present.
Contact the retailer that you purchased from, or FDT directly if anything is broken or missing in the
package.
Note: Prior to installation, ensure that the installation environment can support at least 3 times the
weight of the camera. And do not place objects on top of the camera.
There are two way to install the camera :
Check Hardware
Hardware Installation
When you receive the product in the packaging, unpack it and check all sides of the product for
any physical damage. The protective materials used in the packaging of the product can protect
most accidental damage during transportation, but to ensure that your equipment is operating as
expected, it is recommended to inspect the product before proceeding further.
On the product, check specifically that the label on the bottom of the product is not damaged. The
serial number of the unit is often needed to provide support.
Please check that all required items for your camera are present and accounted for. If any item is
missing, please contact us as soon as possible so we can send you the missing component.
Note: Hardware may not look exactly as pictured in this section, but the steps to assemble the
hardware are the same.