Data Sheet

FSC-BT1006A Datasheet
Shenzhen Feasycom Technology Co.,Ltdwww.feasycom.com
-16-
PSKEY_HOSTIO_UART_RESET_TIMEOUT is set to a value more than 1000
A reboot function is also available under software control.
4.2.1Digital Pin States on Reset
This table shows the pin states of FSC-BT1006A on reset. PU and PD default to weak values unless specifiedotherwise.
Table 4: Pin States on Reset
Pin Name/Group
I/O Type
Full Chip Reset
USB_DP
Digitalbidirectional
Tristate
USB_DN
Digitalbidirectional
Tristate
PIO0
Digitalbidirectional
Strong pull-up
PIO1
Digitalbidirectional
Strong pull-up
PIO2
Digitalbidirectional
Weak pull-down
PIO3
Digitalbidirectional
Weak pull-down
PIO4
Digitalbidirectional
Weak pull-down
PIO5
Digitalbidirectional
Weak pull-down
PIO6
Digitalbidirectional
Strong pull-down
PIO7
Digitalbidirectional
Strong pull-down
PIO8
Digitalbidirectional
Strong pull-up
PIO9
Digitalbidirectional
Strong pull-down
PIO16
Digitalbidirectional
Strong pull-up
PIO17
Digitalbidirectional
Strong pull-down
PIO18
Digitalbidirectional
Weak pull-down
PIO21
Digitalbidirectional
Weak pull-down
4.3 General Purpose Analog IO
FSC-BT1006A has 1 general-purpose analogue interface pins, AIO0.Typically, this pin connects to a thermistor
forbattery pack temperature measurements during charging.
4.4 General Purpose Digital IO
FSC-BT1006A provides up to 14 lines of programmable bidirectional I/O, PIO[21,18:16,9:0].
4.5 RF Interface
For this module, the antenna must be connected to work properly.
The user can connect a 50ohm antenna directly to the RF port.
2402–2480 MHz Bluetooth 5.0 Dual Mode (BT and BLE); 1 Mbps to 3 Mbps over the air data rate.
TX output power of +9dBm(MAX).
Receiverto achieve maximum sensitivity -92dBm @ 1 Mbps BLE or Classic BT, 2 Mbps, 3 Mbps.