Data Sheet

FSC-BT1006A Datasheet
Shenzhen Feasycom Technology Co.,Ltdwww.feasycom.com
-46-
This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and
Economic Development Canada’s licence-exempt RSS(s). Operation is subject to the following two conditions:
(1) This device may not cause interference.
(2) This device must accept any interference, including interference that may cause undesired operation of the
device.
L’émetteur/récepteur exempt de licencecontenudans le présentappareilestconforme aux CNR d’Innovation,
Sciences et Développementéconomique Canada applicables aux appareils radio exempts de licence.
L’exploitationestautorisée aux deux conditions suivantes :
(1) L' appareil ne doit pas produire de brouillage;
(2) L' appareildoit accepter tout brouillageradioélectriquesubi, mêmesi le brouillageest susceptible d'
encompromettre le fonctionnement.
Radio Frequency Exposure Statement for IC
The device has been evaluated to meet general RF exposure requirements. The device can be used in mobile
exposure conditions. The min separation distance is 20cm.
Déclaration d'exposition aux radiofréquences pour IC
L'appareil a été évalué pour répondre aux exigences générales en matière d'exposition aux RF. L'appareil peut
être utilisé dans des conditions d'exposition mobiles. La distance de séparation minimale est de 20 cm.
Module statement
The single-modular transmitter is a self-contained, physically delineated, component for which compliance can
be demonstrated independent of the host operating conditions, and which complies with all eight requirements
of § 15.212(a)(1) as summarized below.
1) The radio elements have the radio frequency circuitry shielded.
2) The module has buffered modulation/data inputs to ensure that the device will complywith Part 15
requirements with any type of input signal.
3) The module contains power supply regulation on the module.
4) The module contains a permanently attached antenna.
5) The module demonstrates compliance in a stand-alone configuration.
6) The module is labeled with its permanently affixed FCC ID label.
7) The module complies with all specific rules applicable to the transmitter, including all the conditions provided
in the integration instructions by the grantee.
8) The module complies with RF exposure requirements.