Data Sheet

FSC-BT806BDatasheet
Shenzhen Feasycom Technology Co.,Ltdwww.feasycom.com
-54-
This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject to the
following two conditions: (1)this device may not cause interference, and(2) this device must accept any
interference, includinginterference that may cause undesired operation of the device.
Le présentappareilestconforme aux CNR d'Industrie Canada applicablesauxappareils radio exempts de
licence. L'exploitationestautorisée aux deux conditions suivantes :(1) l'appareil ne doit pas produire de
brouillage, et(2) l'utilisateur de l'appareildoit accepter tout brouillageradioélectriquesubi, mêmesi le
brouillageest susceptible d'encompromettrelefonctionnement.
Radio Frequency Exposure Statement for IC
The device has been evaluated to meet general RF exposure requirements. The device can be used in mobile
exposure conditions. The min separation distance is 20cm.
Déclaration d'exposition aux radiofréquences pour IC
L'appareil a été évalué pour répondre aux exigences générales en matière d'exposition aux RF. L'appareil peut
être utilisé dans des conditions d'exposition mobiles. La distance de séparation minimale est de 20 cm.
Module statement
The single-modular transmitter is a self-contained, physically delineated, component for which compliance can
be demonstrated independent of the host operating conditions, and which complies with all eight requirements
of § 15.212(a)(1) as summarized below.
1) The radio elements have the radio frequency circuitry shielded.
2) The module has buffered modulation/data inputs to ensure that the device will complywith Part 15
requirements with any type of input signal.
3) The module contains power supply regulation on the module.
4) The module contains a permanently attached antenna.
5) The module demonstrates compliance in a stand-alone configuration.
6) The module is labeled with its permanently affixed FCC ID label.
7) The module complies with all specific rules applicable to the transmitter, including all the conditions provided
in the integration instructions by the grantee.
8) The module complies with RF exposure requirements.
NOTE: This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is encouraged to
try to correct the interference by one or more of the following measures: