Data Sheet

Module statement
The single-modular transmitter is a self-contained, physically delineated, component
for which compliance can be demonstrated independent of the host operating
conditions, and which complies with all eight requirements of § 15.212(a)(1) as
summarized below.
1) The radio elements have the radio frequency circuitry shielded.
2) The module has buffered modulation/data inputs to ensure that the device will
comply with Part 15 requirements with any type of input signal.
3) The module contains power supply regulation on the module.
4) The module contains a permanently attached antenna.
5) The module demonstrates compliance in a stand-alone configuration.
6) The module is labeled with its permanently affixed FCC ID label
7) The module complies with all specific rules applicable to the transmitter, including
all the conditions provided in the integration instructions by the grantee.
8) The module complies with RF exposure requirements.
This transmitter/module must not be collocated or operating in conjunction with
any other antenna or transmitter.
Integration instructions for host product manufacturers according to KDB 996369
D03 OEM Manual v01
2.2 List of applicable FCC rules
FCC Part 15.247
2.3 Specific operational use conditions
This transmitter/module and its antenna(s) must not be co-located or operating in
conjunction with any transmitter. This information also extends to the host
manufacturer’s instruction manual.
2.4 Limited module procedures
not applicable
2.5 Trace antenna designs
not applicable
2.6 RF exposure considerations
This equipment complies with FCC RF radiation exposure limits set forth for an
uncontrolled environment. This compliance to FCC radiation exposure limits for an
uncontrolled environment, and minimum of 5mm separation between antenna and
body.
The host product manufacturer would provide the above information to end users in
their end-product manuals.
2.7 Antennas
PCB antenna; 2dBi; 2.402 GHz～2.480GHz
FCC ID: 2AMWOFSC-BT825
FCC ID: 2AMWOFSC-BT825
2.8 Label and compliance information
The end product must carry a physical label or shall use e-labeling followed
KDB784748D01 and KDB 784748 stating “Contains Transmitter Module FCC ID:
2AMWOFSC-BT825”.
2.9 Information on test modes and additional testing requirements
For more information on testing, please contact the manufacturer.
2.10 Additional testing, Part 15 Subpart B disclaimer
The modular transmitter is only FCC authorized for the specific rule parts (FCC Part
15.247) listed on the grant, and that the host product manufacturer is responsible
for compliance to any other FCC rules that apply to the host not covered by the
modular transmitter grant of certification. The final host product still requires Part
15 Subpart B compliance testing with the modular transmitter installed when
contains digital circuity.