Users Manual

Integration instructions for host product manufacturers according to KDB 996369 D03
OEM Manual v01
2.2 List of applicable FCC rules
CFR 47 FCC PART 15 SUBPART C has been investigated. It is applicable to the modular.
2.3 Specific operational use conditions
This module is stand-alone modular. If the end product will involve the Multiple simultaneously
transmitting condition or different operational conditions for a stand-alone modular transmitter
in a host, host manufacturer have to consult with module manufacturer for the installation
method in end system.
2.4 Limited module procedures
Not Applicable
2.5 Trace antenna designs
Not applicable
2.6 RF exposure considerations
The device has been evaluated to meet general RF exposure requirement. in portable
exposure condition without restriction.
2.7 Antennas
This radio transmitter FCC ID: 2AMWOFSC-BT826E has been approved by Federal
Communications Commission to operate with the antenna types listed below, with the
maximum permissible gain indicated. Antenna types not included in this list that have a gain
greater than the maximum gain indicated for any type listed are strictly prohibited for use with
this device.
Internal
Identification
Antenna
Description
Antenna type
and antenna
number
Operate frequency
band
Maximum
antenna gain
Antenna 1
Bluetooth
Antenna
PCB Antenna
2400 MHz – 2500
MHz
2.00 dBi
2.8 Label and compliance information
The final end product must be labeled in a visible area with the following" Contains FCC ID:
2AMWOFSC-BT826E”