Data Sheet

FSC-BT956B Datasheet
Shenzhen Feasycom Technology Co., Ltd www.feasycom.com
-29-
11. APPLICATION SCHEMATIC
FCC Statements
(OEM) Integrator has to assure compliance of the entire end-product incl. the integrated RF Module. For 15 B
(§15.107 and if applicable §15.109) compliance, the host manufacturer is required to show compliance with 15
while the module is installed and operating.
Furthermore the module should be transmitting and the evaluation should confirm that the module's intentional
emissions (15C) are compliant (fundamental / out-of-band). Finally the integrator has to apply the appropriate
equipment authorization (e.g. Verification) for the new host device per definition in §15.101.
Integrator is reminded to assure that these installation instructions will not be made available to the end-user of
the final host device.
The final host device, into which this RF Module is integrated" has to be labeled with an auxiliary label stating
the FCC ID of the RF Module, such as "Contains FCC ID：2AMWOFSC-BT956B"
This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions:
(1)this device may not cause harmful interference, and
(2)this device must accept any interference received, including interference that may cause undesired
operation."
"Changes or modifications to this unit not expressly approved by the party responsible for compliance could
void the user’s authority to operate the equipment."
the Integrator will be responsible to satisfy SAR/ RF Exposure requirements, when the module integrated into
the host device.
Module statement
The single-modular transmitter is a self-contained, physically delineated, component for which compliance can
be demonstrated independent of the host operating conditions, and which complies with all eight requirements
of § 15.212(a)(1) as summarized below.
1) The radio elements have the radio frequency circuitry shielded.
2) The module has buffered modulation/data inputs to ensure that the device will comply with Part 15
requirements with any type of input signal.
3) The module contains power supply regulation on the module.
4) The module contains a permanently attached antenna.
5) The module demonstrates compliance in a stand-alone configuration.
6) The module is labeled with its permanently affixed FCC ID label.
7) The module complies with all specific rules applicable to the transmitter, including all the conditions provided
in the integration instructions by the grantee.
8) The module complies with RF exposure requirements.