Data Sheet

FSC-BT956B Datasheet
Shenzhen Feasycom Technology Co., Ltd www.feasycom.com
-30-
NOTE: This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is encouraged to
try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
-Consult the dealer or an experienced radio/TV technician for help
Integration instructions for host product manufacturers according to KDB 996369 D03 OEM Manual v01
2.2 List of applicable FCC rules
FCC Part 15.247
2.3 Specific operational use conditions
This transmitter/module and its antenna(s) must not be co-located or operating in conjunction with any transmitter.
This information also extends to the host manufacturer’s instruction manual.
2.4 Limited module procedures
not applicable
2.5 Trace antenna designs
not applicable
2.6 RF exposure considerations
This equipment complies with FCC RF radiation exposure limits set forth for an uncontrolled environment. This
compliance to FCC radiation exposure limits for an uncontrolled environment, and minimum of 5mm separation
between antenna and body.
The host product manufacturer would provide the above information to end users in their end-product manuals.
2.7 Antennas
PCB antenna; 2dBi; 2.402 GHz～2.480GHz
2.8 Label and compliance information
The end product must carry a physical label or shall use e-labeling followed KDB784748D01 and KDB 784748
stating “Contains Transmitter Module FCC ID: 2AMWOFSC-BT956B”.