User Manual

ManualsBrandsFEBCO ManualsAccessories for waterFPHB-1 Key Operated Wall Hydrants for Irrigation System Winterization

IS-F-FPHB-1

INSTALLATION INSTRUCTIONS

Series FPHB-1 Wall Hydrants

Sizes:

⁄4" and 1" (20 and 25mm)

Installation Instructions

1. Drill a 1

⁄8" diameter hole in the wall and insert the barrel through

the wall.

2. Determine system requirements:

a. If using a vacuum breaker, install the union outlet of the FPHB-1

Hydrant in the vertical up position (see Fig. 1 and Fig. 2)

b. If using a Reduced Pressure Assembly, install the union outlet of the

FPHB-1 Hydrant in the vertical up orientation (see Fig. 1 and Fig. 3).

c. If using a Double Check Assembly in meter box (see Fig. 4 and Fig.

5), install the union outlet in the vertical down position.

3. Secure to the wall, anchoring through the faceplate.

4. Connect the threaded

⁄4" or 1" inlet to the domestic supply. (see Fig. 1)

5. If the inside connection is to be a sweat (soldered) connection, turn

hydrant key counter-clockwise to the full open position. Wrap hydrant

side connection with a wet rag and/or heat sink before applying heat.

6. Restore water supply, slowly open hydrant and flush thoroughly.

7. Connect union outlet to the backflow preventer.

Note: FPHB-1 does not include Backflow Prevention Assembly. Consult

local codes for proper protection.

Note: The FPHB-1 is designed for maximum flow and should be oper-

ated in the wide open position. The FPHB-1 hydrant should not be used

as a throttling valve.

Figure 1

Size

⁄4" and 1" (20 and 25mm)

MODEL NOM. PIPE STEM

Distance Length (in.) Length (in.)

FPHB-1-8 8.0 9.0 12.3

FPHB-1-10 10.0 11.0 14.3

FPHB-1-12 12.00 13.0 16.3

O-Ring

Plumbing Assembly

Valve Body

Head Body

Union Nut

Key

Drain Plug,

Blow Down

Seat

Summary of content (2 pages)

PAGE 1
IS-F-FPHB-1 INSTALLATION INSTRUCTIONS Series FPHB-1 Wall Hydrants Sizes: 3⁄4" and 1" (20 and 25mm) Installation Instructions 1. Drill a 17⁄8" diameter hole in the wall and insert the barrel through the wall. 2. Determine system requirements: 5. If the inside connection is to be a sweat (soldered) connection, turn hydrant key counter-clockwise to the full open position. Wrap hydrant side connection with a wet rag and/or heat sink before applying heat. a.
PAGE 2
MAINTENANCE MANUAL Installation Instructions Figure 2 Figure 3 FPHB-1 with 828Y Series Reduced Pressure Backflow Preventer FPHB-1 with FEBCO 767FR Series Pressure Vacuum Breaker Key To Sprinklers Water Supply Key Water Supply Drain Port or Blow Down To Sprinklers FEBCO FPHB-1 Drain Port or Blow Down FEBCO FPHB-1 Note: PVB’s must be installed a minimum of 12" above the highest point of water in the sprinkler system. Note: RPZ’s must be installed a minimum 12" above ground level.