Installation Guide

www.federalbrace.com [phone]
Furniture Feet | Wiltshire
Every successful furniture foot installation begins with good
planning and action. Be sure to plan for the proper amount of
parts required for your project and the correct fastening compo-
nents. Make sure that all aspects of the furniture or cabinet you
are supporting are considered and discussed to insure that your
furniture foot installation will be smooth and that your support
products will be sufcient.
Note that this installation document should not be considered a
specic recommendation for your particular application. Federal
Brace cannot provide installation guidelines to meet the partic-
ulars of every application. This document should be considered
a help sheet that provides considerations about the general
characteristics of a particular type of support and installation
Characteristics of the Wiltshire Furniture Foot
Our Wiltshire Furniture Foot is designed to be mounted to the
bottom of a cabinet, island or a piece of furniture. The thick
stainless steel material is designed to support all types of
applications and the weight that might accompany the cabinet
or furniture.
Preparations for the Wiltshire Furniture Foot
The installation of our Wiltshire Furniture Foot will require a
hanger bolt or a dowel. This will be determined by what you are
installing the Wiltshire on and how the receiving end is made. If
mounting directly into wood with a pilot hole then a hanger bolt
is required. If a threaded insert is in place on the furniture then it
will receive a dowel to install.
Considerations when Installing the Wiltshire
Furniture Foot
The Wiltshire should be installed on all four corners of cabinets
and furniture where applicable. You will want to make sure your
furniture or cabinet base is prepped for the furniture foot. This
may mean drilling a pilot hole if you are using a hanger bolt or
a larger hole if a threaded insert is the desired install method.
Insert the hanger bolt (ne thread end) or dowel into the tapped
hole on the Wiltshire till you meet the corse threads on the hang-
er bolt or half the length of the dowel. If using the hanger bolt,
drill a pilot hole into the wood bottom of the cabinet or furniture
piece. Insert the hanger bolt and tighten until the foot is ush.
Wiltshire Furniture Feet
Installation Guidelines
Vendor #34606