Installation Instructions

ManualsBrandsFeeney ManualsBuilding materials44" Aluminum Intermediate Picket for Level Railings

1-800-888-2418 | www.feeneyinc.com

• Transfer the cut length from Step 1 onto the corresponding picket and

mark the cut locations.

• Trim the picket at the cut marks using a miter saw with a fine-toothed

carbide-tipped blade.

Important Note: double check your cut marks to be sure that

once the picket is cut and base plates attached, the cable drill

holes will align with the drill holes on your post.

STEP 2 - Mark & Trim Picket

(with bottom rail)

(without bottom rail)

MEASURE

STEP 1 - Measure Opening

• Measure the distance between top and bottom rail or top rail and

deck surface.

• Subtract 3/8” from your measurement to account for the base plates,

this will be your picket cut length.

Feeney® Intermediate Pickets are non-structural railing members designed to help maintain CableRail spacing and minimize cable deection. The #7648 kits

are for level wood railing frames (with or without bottom rails) up to 42” high and having 1/8” CableRail inll cables spaced 3” on center. Before beginning

installation, the entire railing frame must be constructed and posts drilled for the CableRail inll. We recommend that you have a vertical member, either post

or intermediate picket, spaced no further than 3-ft on center. Consult local building code for all railing construction requirements in your area.

Kit Contents: (1x) 44” Intermediate Picket with 13 cable holes spaced 3“ on center, (2x) Base Plates, (6x) #10x1” stainless steel #2 Square Drive Screws

Tools Required: safety glasses, hearing protection, work gloves, measuring tape, pencil, miter saw with ne-toothed carbide-tipped blade,

electric drill/driver, #2 square drive bit, 1/8” drill bit, level

Installation Instructions

Feeney

Intermediate Picket (SKU#7648) - For Level Railings Only

v 04/2013

Summary of content (2 pages)

PAGE 1
Installation Instructions v 04/2013 Feeney® Intermediate Picket (SKU#7648) - For Level Railings Only Feeney® Intermediate Pickets are non-structural railing members designed to help maintain CableRail spacing and minimize cable deflection. The #7648 kits are for level wood railing frames (with or without bottom rails) up to 42” high and having 1/8” CableRail infill cables spaced 3” on center.
PAGE 2
v 04/2013 Installation Instructions Feeney® Intermediate Picket (SKU#7648) - For Level Railings Only STEP 3 - Attach Base Plates STEP 4 - Attach Picket to Railing • Screw the Base Plates to both ends of the picket using an electric drill with a #2 square drive bit. Important Note: To prevent screw head damage and ease installation, lubricate the screw threads with wax or soap prior to attachment and drive the screws slowly and smoothly with minimal stopping and starting.