Installation Instructions

for DesignRail

Aluminum Post Kits for CableRail

• 36” high stair railing for residential applications

• Pre-drilled posts for cable infill

• Use only with DesignRail

Aluminum Rail Kits and CableRail by Feeney

1-800-888-2418 | www.feeneyinc.com

Tools Needed:

- Safety glasses

- Ear protection

- Gloves

- Measuring tape

- Electric drill

- #2 square-drive bits

- Drill bits, assorted sizes

- 7/16” socket wrench

- 9/16” socket wrench

Note: DesignRail

Kits will handle most railing conditions; however, if your railing requirements

vary from those noted, please check with your retailer’s special order desk to determine other

DesignRail

options that may be special ordered to suit your exact project needs. Before

beginning your project, thoroughly review all of the installation instructions for this railing

system and the CableRail infill to ensure that the railing styles and sizes meet your local

building code requirements. Spacer materials or other physical barriers are recommended to

prevent direct contact of pressure treated wood with aluminum products. Check building codes

for latest information.

Parts List:

1- Post

1- Post Cap

4- 3/8” Lag Screws

4- Retaining Washers

4- Lag Screw Caps

2- Screws

STAIR

PAGE 1
Installation Instructions for DesignRail® Aluminum Post Kits for CableRail • 36” high stair railing for residential applications • Pre-drilled posts for cable infill • Use only with DesignRail® Aluminum Rail Kits and CableRail by Feeney STAIR Tools Needed: - Safety glasses - Ear protection - Gloves - Measuring tape - Electric drill - #2 square-drive bits - Drill bits, assorted sizes - 7/16” socket wrench - 9/16” socket wrench Parts List: 1- Post 1- Post Cap 4- 3/8” Lag Screws 4- Retaining Washers 4- Lag
PAGE 2
STAIR POST INSTALLATION: Note: Stair Kits accommodate 6-ft maximum length stairway, and a stair slope of between 29 and 34 degrees. Since Kits are less than 6-ft, they do not require Intermediate Posts. Always position the Threaded Terminal End Posts at the bottom of the stairs and the Quick-Connect® End Posts at the top. Step 1 – Attach Posts a) Determine the exact position of the top posts (Stair Quick-Connect® End Posts) and bottom posts (Stair Threaded Terminal End Posts).