Falwell FOR CUSTOMERS Thank you for purchasing our dehumidifier. ##hmw has been committed to developing powerful and easy-to-use products to bring more convenience to your life. We highly recommend you to keep this user manual for future reference in case of unexpected problems. Please read this user manual carefully to ensure proper use of the dehumidifier. This dehumidifier is perfect for reducing humidity in family bedrooms, bathrooms, basements, offices, storage rooms and more.
BEFORE FIRST USE: To protect the product from any internal damages, please keep the product in the upright position throughout its journey. Please take out the product and leave it standing in the upright position for 24 HOURS before plugging tin.
Faun TABLE OF CONTENTS Precautions for Use... 034 Parts Description... 02 Operation Instructions vexes career serene 0% Cleaning and £2 err —— £3 re, 14 Special Notes... 17 Warranty and Contact 18 Statement The graphics and functions provided in this manual maybe not the same as the actual product. The model shown in this manual is only for reference. Please install and operate the machine according to the actual situations. The company reserves the right to interpret relevant terms.
PRECAUTIONS FOR USE «= Before cleaning the dehumidifier, please turn off the machine and unplug it from the power source. # Please do not place the machine near heat or flammable goods. «= Do not put any sticks or your fingers into ths air inlet or outset. « Please always place the machine en a flat ground, rather than uneven or slopping ones. # Do not spray water, insecticides or flammable liquids on the machine. # Please do not place the machine in a confined or narrow space.
| OPERATION OBSTRUCTIONS 1.
OPERATION OBSTRUCTIONS 2. Betting Humidity Setting The humidity level can be set within the range Increments. + When the machine starts to work, it will automatically detect and show the room humidity first. In humidification mode, press the " eS * button to set the humidity in 5% increments. Then it will flash "5H £" and show the set humidity. Now you can set the humidity within the range increments. If you do not operate the machine for 5 seconds, "5H" will show the actual room humidity.
OPERATION OBSTRUCTIONS Speed Button Press this button to control the fan speed. By pressing it, you can choose either High or Low speed. Higher speed results in quicker moisture removal. So when you want to reduce the humidity quickly, please choose the High speed; If you have reduced the humidity or prefer quieter operation, please choose the Low speed. DRY (Laundry Dry) Mode Press the “ " button until you see the “DRY" indicator light up on the display to select DRY-CLOTHES mode.
OPERATION OBSTRUCTIONS 3. Display Status Description « When the device is currently powered on, when turning it off only the POWER" will light up indicating device is in "Standby" status. « Setting light *@ v: If the timer is setup properly, the indicator will light up. Otherwise, the indicator will be off. « High-speed indicator light” "5" *: If you set the high speed, this indicator will light up. « Low-speed indicator light " ER you set the low speed, this indicator will light up.
OPERATION OBSTRUCTIONS £ Faults and Solutions Humidity always shows "25% RH" but there is a big difference from the actual humidity. Humidity always shows "89% RH" but there Is a big difference from the actual humidity. Does the humidity sensor fall? Set the humidity to 30% RH and check if the dehumidifier can work normally. Fit soda, the machine is in a good condition. Repair or replace the humidity sensor. Is there some water on the surface of the humidity sensor? ‘The dehumidifier cen work normally.
OPERATION OBSTRUCTIONS &. Property the Tank or Bucket There are two ways to remove collected water. Using the Bucket When the water tank is full, the full tank alert indicator will light up and the dehumidifier will automatically shutdown until the tank is emptied and placed back to the machine. Ways to Empty the Water Tank Here is the water outlet. Eternity the water bucket. Place the water bucket back property.
OPERATION OBSTRUCTIONS Note: Do not removes the float in the water tank. Otherwise, the sensor maybe unable to identify the water level in the tank properly, thus causing water leakage. If the water tank is dirty, please use cold or warm water to clean it. Do not use any detergents, steel wool, chemically-treated dust clothes, gasoline, benzene, thinners or other solvents. Otherwise, it may damage the water tank and cause it to leak.
OPERATION OBSTRUCTIONS Continuous Drainage To continuously drain, please unplug the machine from the power source first. Then take out the water tank and open the drain cover. Now insert the drain hose into the continuous drain port and place the water tank back to its original place. Plug the machine into the power source to start continuous drainage. Please make sure that the drain hose should be lower than the continuous drain port by at least 3.8 inches. Do not bend the drain hose.
OPERATION OBSTRUCTIONS BE. Smart Functions Auto Shut Off When the bucket is full and/or the room humidity reaches the set point, the dehumidifier will stop working automatically. Wait 3 Minutes Before Resuming Operation To avoid any damage to the dehumidifier, the compressor will not start operation following a complete cycle until after 3 minutes. The operation will automatically start after 3 minutes.
CLEARING AND MAINTENANCE FS Please turn off the dehumidifier and unplug it from the power source before cleaning. A-Cleaning the Dehumidifier Body Please use a soft and slightly damp cloth to clean the humidifier body. B Cleaning the Filter 1. Pull out the filter. 2. Clean the filter: Use a vacuum cleaner to gently remove the dust from the surface of the filter. If the filter is very dirty, wipe it with warm water and a mild detergent and dry it completely. 3.
FLOTATIONS MODEL DOSS POWER SOURCE 120V~60Hz RATED POWER 400W RATED CURRENT 3.6A MOISTURE 15 Pints/Day MOISTURE REMOVAL(80 F60%RH) 23 Pints/Day MOISTURE REMOVAL(86 F80%RH) 40 Pints/Day MOISTURE REMOVAL(95 F90%RH) 50 Pints/Day INPUT 200W INPUT 1.8A 1.30 Whitehorse MOTOR FLA 023A MOTOR COMPRESSOR REFRIGERANT MAXIMUM ALLOWABLE PRESSURE pampas MAXIMUM OPERATING PRESSURE HIGH 1.6MPa MAXIMUM OPERATING PRESSURE LOW 0.
SCRIBBLE Check the information below for troubleshooting the common problems you may encounter in the future. These abnormal conditions that are not faults caused by manufacturing process or material defects. If the malfunctions still exist, pleads feel free to contact Fathom customer service for help. leash elms possible Causes Dehumidifier doss not work The power cord Is unplugged. Make sure that the unit's plug is Inserted properly Into the power outlet.
Dehumidifier does not dry the air as it should The air filter is dirty. Clean the air filter. Is the alr Inlet or alr loutish obstructed? Remove the obstruction from the air inst or outlet. The dehumidifier size Is too small for application. Increase the quantity of dehumidifier. Or sang capacity dehumidifier. higher Poor air circulation. ve about [around the product. Did not allow enough time to remove the moisture. Allow enough time to remove the moisture.
The connection between the hose and port may be loose. Connect the hoses with the drain outlet tightly. The water tank Is not Installed properly. Re-install the water bucket properly. Overflow of water on floor The float of the water tank has | Move the float and make sure sunk. It can swing fresh. Th t on tha float h: off regnetanthatloathas come | routine magnet in right position.
SPECIAL NOTES £% Do insertions thin rods or hard Item Into the machine to ant prevent malfunctions and dangers. Please do not put any objects around the machine. The humidification effect will be affected If the ventilation Is bad. £5 When using the machine, please do not putt o or haven ground to prs vibration and movement. i £5 When using the machine, pleads close doors and windows for the optimal moisture removal affect.
WARRANTY AND CONTACT US Warranty Fathom offers a 12-month warranty to all of our products together with the original proof of purchase when a defect occurred, including those newly purchased and unused, from Fathom or through an authorized reseller, wholly or substantially, or as a result of faulty manufacturing parts, or workmanship during the Warranty Period.