User Manual

Treadmill Maintenance
Proper maintenance is very important to ensure a faultless and operational condition of the treadmill.
Improper maintenance can cause damage to the treadmill or shorten the life of the product.
All parts of the treadmill must be checked and tightened regularly. Worn out parts must be replaced
immediately.
BELT ADJUSTMENT
You may need to adjust the running belt during the first few weeks of use. All running belts are properly set at
the factory. It may stretch of be off center after use. Stretching is normal during the break-in period.
ADJUSTING THE BELT TENSION:
If the running belt feels as though it is slipping or hesitating when you plant your foot during a run, the tension
on the running belt may have to be increased.
TO INCREASE THE RUNNING BELT TENSION:
1. Place 8mm wrench on the left belt tension bolt. Turn the wrench clockwise 1/4 turn to draw the rear roller
and increase the belt tension.
2. Repeat STEP 1 for the right belt tension bolt. You must be sure to turn both bolts the same number of
turns, so the rear roller will stay square relative to the frame.
3. Repeat STEP 1 and STEP 2 until the slipping is eliminated.
4. Be careful not to tighten the running belt tension too much as you can create
An excessively tightened running belt may damage the roller bearings that would result in bearing noise from
the front and rear rollers.
TO DECREASE THE TENSION ON THE RUNNING BELT, TURN BOTH BOLTS COUNTER-CLOCKWISE
THE SAME NUMBER OF TRUNS.
CENTRING THE RUNNING BELT
When you run, you may push off harder with one foot than with another. The severity of the deflection
depends on the amount of force that one foot exerts in the relation to the other. This deflection can cause the
belt to move off- center. This deflection is normal and the running belt will center when nobody is on the
running belt. If the running belt remains consistently off-center, you will need to center the running belt
manually.
Start the treadmill without anyone on the running belt, increase speed to 6km/kh.
1. Observe whether the running belt is toward the right or left side of the deck.
●If toward the left side of the deck, using wrench, turn the left adjustment bolt clockwise 1/4 turn and the left
adjustment bolt counter clockwise 1/4.
● If toward the right side of the deck, turn the right adjustment bolt clockwise 1/4 turn and the left
adjustment bolt counter clockwise 1/4.
● If the belt is still not center, repeat the above step until the running belt is on center.
2. After the belt is center, increase the speed to 13kph and verify that it is running smoothly. Repeat the
27