User Manual

above steps if it is necessary.
If the above procedure is unsuccessful in resolving the off-centre, you may need to increase the belt tension.
LUBRICATION
The treadmill is factory-lubricated. However, it is recommended to check the lubrication of the treadmill
regularly, to ensure an optimal operation of the treadmill. It is usually not necessary to lubricate the treadmill
in the first year or the first 500 hours of operation.
After every 3 months of operation, lift the sides of the treadmill and feel the surface of the belt, as far as
possible. If traces of silicon spray are found, lubrication is not
necessary.
In case of a dry surface refer to the following instructions.
Only use oil free silicon spray.
Application of lubricant on the belt:
● Position the belt so that the seam is located in the middle of the
plate.
● Insert the spray valve in the spray head of the lubricant container.
● Lift the belt at one side and hold the spray valve in a distance to the
front end of striding belt and plate. Start at the front end of the belt. Lead the spray valve in direction of the
back end. Repeat this process on the other side of the belt. Spray each side for about 4 seconds.
● Wait 1 minute to let the silicon spray spread, before starting the machine.
CLEANING:
Regular cleaning of the striding belt ensures a long product life.
● Warning: The treadmill must be turned off to avoid electrical shocks. The power cord must be pulled out
of the socket, before starting the cleaning or maintenance.
●After each training: Wipe the console and other surfaces with a clean soft and damp cloth to remove sweat
residues.
Caution: Do not use any abrasives or solvents. To avoid damage to the computer, keep any liquids away. Do
not expose the computer to direct sunlight.
●Weekly: To make the cleaning easier it is recommended to use a mat for the treadmill. Shoes can leave
dirt on the striding belt that can fall beneath the treadmill. Clean the mat under the treadmill once a week.
STORAGE:
Store you treadmill in a clean and dry environment. Ensure the master power switch is off and is un-plugged
from the electrical wall outlet.
28