User's Manual
Table Of Contents
- Annex no. 5 (Functional Description - User Manual).pdf
- M90113-10e-PY-B.pdf
- 1 Warnings – Read Before Start-Up!
- 2 Characterization
- 3 Functional Elements
- 4 Mechanical Integration
- 5 Connectors
- 5.1 Connector X1 – Power Supply and MDB Interface
- 5.2 Standby Mode / Wake-Up
- 5.3 Connector X2 – USB Device Interface
- 5.4 Connector X3 – COM 0 (RS232 V.24 Interface)
- 5.5 Connector X4 – USB Host 2 Interface
- 5.6 Connector X5 – Ethernet Interface
- 5.7 Connector X6 - Auxiliary
- 5.8 Connector X7 – USB Host 1
- 5.9 Connector X8 – cVEND SHCR
- 5.10 Connector X9 – COM 2 (RS232 V.24)
- 5.11 SAM Sockets (S1, S2)
- 6 Installation and Setup
- 7 Maintenance and Cleaning
- 8 User Interface
- 9 Technical Data
5 Connectors
Page 18 of 38
5.2 Standby Mode / Wake-Up
cVEND offers a software programmable standby mode. To activate the normal operation mode the following
wake-up sources are provided.
MDB wake-up by host:
If standby is activated the bi-directional wake-up I/O is used for signaling a wake-up event by the cVEND and
can be used by the host to activate the cVEND. The host controller can awake the cVEND by pulling down
the wake-up line.
Wake-up “OK” Key:
Pressing the “OK” key on the key pad will awake the cVEND.
Time controlled wake-up:
The firmware provides functions for software programmable wake-up. This functionality depends on the
installed application.
NOTE:
The USB connection will be interrupted during standby mode.
Fig. 11: cVEND PIN Internal Wake-Up Circuit