User's Manual
Table Of Contents
- Annex no. 5 (Functional Description - User Manual).pdf
- M90113-10e-PY-B.pdf
- 1 Warnings – Read Before Start-Up!
- 2 Characterization
- 3 Functional Elements
- 4 Mechanical Integration
- 5 Connectors
- 5.1 Connector X1 – Power Supply and MDB Interface
- 5.2 Standby Mode / Wake-Up
- 5.3 Connector X2 – USB Device Interface
- 5.4 Connector X3 – COM 0 (RS232 V.24 Interface)
- 5.5 Connector X4 – USB Host 2 Interface
- 5.6 Connector X5 – Ethernet Interface
- 5.7 Connector X6 - Auxiliary
- 5.8 Connector X7 – USB Host 1
- 5.9 Connector X8 – cVEND SHCR
- 5.10 Connector X9 – COM 2 (RS232 V.24)
- 5.11 SAM Sockets (S1, S2)
- 6 Installation and Setup
- 7 Maintenance and Cleaning
- 8 User Interface
- 9 Technical Data
5 Connectors
Page 20 of 38
5.4 Connector X3 – COM 0 (RS232 V.24 Interface)
X3 is the connector for an RS232 interface on V.24 level and is primarily intended as a cash register
interface.
Pin
Label
Direction
Remarks
1
Device RXD
I
2
Device TXD
O
3
Wake-Up
I/O
see 5.2
4
GND
-
Table 7: Pin Assignment RS232 V.24 Interface (X3)
Required Connector:
The fitting complement for this connector consists of a 4-pole plug type Molex Micro Fit and the appending
crimp contact.
Manufacturer Ordering Code:
• Molex 43025-0400
Plug, 4-pole, grid dimension 3.0 mm, dual row, Molex Micro Fit housing
• Molex 43030-0001
Crimp contact, female, grid dimension 3.0 mm, AWG#20-24, Molex Micro Fit
NOTE:
The RS232 interface is designed for max. 3 m (9.8 ft) cable length.
Fig. 13: Connector X3 – COM 0