User's Manual
Table Of Contents
- Annex no. 5 (Functional Description - User Manual).pdf
- M90113-10e-PY-B.pdf
- 1 Warnings – Read Before Start-Up!
- 2 Characterization
- 3 Functional Elements
- 4 Mechanical Integration
- 5 Connectors
- 5.1 Connector X1 – Power Supply and MDB Interface
- 5.2 Standby Mode / Wake-Up
- 5.3 Connector X2 – USB Device Interface
- 5.4 Connector X3 – COM 0 (RS232 V.24 Interface)
- 5.5 Connector X4 – USB Host 2 Interface
- 5.6 Connector X5 – Ethernet Interface
- 5.7 Connector X6 - Auxiliary
- 5.8 Connector X7 – USB Host 1
- 5.9 Connector X8 – cVEND SHCR
- 5.10 Connector X9 – COM 2 (RS232 V.24)
- 5.11 SAM Sockets (S1, S2)
- 6 Installation and Setup
- 7 Maintenance and Cleaning
- 8 User Interface
- 9 Technical Data
5 Connectors
Page 23 of 38
5.7 Connector X6 - Auxiliary
On connector X6 an electrically isolated opto-coupler digital output and a connector for an external buzzer
are provided. The opto-coupler digital output is controlled by software and can be used to control a parking
barrier for example. The external buzzer output provides an PWM signal in parallel to the internal buzzer and
can be used to connect a piezo speaker.
Pin
Label
Direction
Remark
1
5 V DC
O
2
External Buzzer
O
PWM Output / max. 24 V DC / 100 mA
3
Opto-Out-C
I
max. 24 V DC / 20 mA / Resistive Load
4
Opto-Out-E
O
Table 9: Pin Assignment Auxiliary Connector (X6)
Required Connector:
The fitting complement for this connector consists of a 4-pole plug type Molex Micro Fit and the appending
crimp contact.
Manufacturer Ordering Code:
• Molex 43645-0400
Plug, 4-pole, grid dimension 3.0 mm, single row, Molex Micro Fit receptacle housing
• Molex 43030-0001
Crimp contact, female, grid dimension 3.00 mm, AWG#20-24, Molex Micro Fit
NOTE:
The interface is designed for max. 3 m (9.8 ft) cable length.
Fig. 16: Connector X6 – AUX