User's Manual
Table Of Contents
- Annex no. 5 (Functional Description - User Manual).pdf
- M90113-10e-PY-B.pdf
- 1 Warnings – Read Before Start-Up!
- 2 Characterization
- 3 Functional Elements
- 4 Mechanical Integration
- 5 Connectors
- 5.1 Connector X1 – Power Supply and MDB Interface
- 5.2 Standby Mode / Wake-Up
- 5.3 Connector X2 – USB Device Interface
- 5.4 Connector X3 – COM 0 (RS232 V.24 Interface)
- 5.5 Connector X4 – USB Host 2 Interface
- 5.6 Connector X5 – Ethernet Interface
- 5.7 Connector X6 - Auxiliary
- 5.8 Connector X7 – USB Host 1
- 5.9 Connector X8 – cVEND SHCR
- 5.10 Connector X9 – COM 2 (RS232 V.24)
- 5.11 SAM Sockets (S1, S2)
- 6 Installation and Setup
- 7 Maintenance and Cleaning
- 8 User Interface
- 9 Technical Data
5 Connectors
Page 25 of 38
5.8 Connector X7 – USB Host 1
On connector X7 a USB host interface is provided, intended to be used for static connected interface
devices. USB host function depends on firmware/software version.
Pin
Label
Direction
1
5 V DC (max. 500 mA)
O
2
USB H–
I/O
3
USB H+
I/O
4
GND
-
5
Shield
-
Table 10: Pin Assignment USB Host 1 Connector (X7)
Required Connector:
The fitting complement for this connector consists of a 5-pole plug type Molex Micro Fit and the appending
crimp contact.
Manufacturer Ordering Code:
• Molex 43645-0500
Plug, 5-pole, grid dimension 3.0 mmm single row, Molex Micro Fit receptacle housing
• Molex 43030-0001
Crimp contact, female, grid dimension 3.0 mm, AWG#20-24, Molex Micro Fit
NOTE:
The USB interface is designed for max. 3 m (9.8 ft) cable length.
Fig. 20: Pin Assignment USB Host 1 on Connector X7