User's Manual
Table Of Contents
- Annex no. 5 (Functional Description - User Manual).pdf
- M90113-10e-PY-B.pdf
- 1 Warnings – Read Before Start-Up!
- 2 Characterization
- 3 Functional Elements
- 4 Mechanical Integration
- 5 Connectors
- 5.1 Connector X1 – Power Supply and MDB Interface
- 5.2 Standby Mode / Wake-Up
- 5.3 Connector X2 – USB Device Interface
- 5.4 Connector X3 – COM 0 (RS232 V.24 Interface)
- 5.5 Connector X4 – USB Host 2 Interface
- 5.6 Connector X5 – Ethernet Interface
- 5.7 Connector X6 - Auxiliary
- 5.8 Connector X7 – USB Host 1
- 5.9 Connector X8 – cVEND SHCR
- 5.10 Connector X9 – COM 2 (RS232 V.24)
- 5.11 SAM Sockets (S1, S2)
- 6 Installation and Setup
- 7 Maintenance and Cleaning
- 8 User Interface
- 9 Technical Data
6 Installation and Setup
Page 29 of 38
6 Installation and Setup
Installation and Setup
6.1 Installation
Before installing, visually inspect the device for any discrepancies to the official product data or unauthorized
modifications. More details can be found in the cVEND PIN Security Policy.
For installation follow these steps:
1. Make sure that the intended installation are is clean and even.
2. Place the cVEND PIN in the cut-out.
3. Screw the device tight at the four screw-on points. Nuts with washer are recommended.
4. Check that all protection foils are removed from the key pad and the display.
5. Check that the power supply complies with the specification.
6. Check that all needed cables are plugged in correctly.
7. Switch on the power supply and start the setup process.
NOTE:
The PIN Entry function is available after terminal setup (see 6.4) only if both removal protection
switches (S1, S2) are activated during installation.