Users Manual Part 1

IC statement
5
This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment
generates uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
¾
Reorient or relocate the receiving antenna.
¾
Increase the separation between the equipment and receiver.
¾
Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
¾
Consult the dealer or an experienced radio/TV technician for help.
IC statement
This device complies with Industry Canada’s licence-exempt RSSs.
Operation is subject to the following two conditions:
1. This device may not cause interference; and
2. This device must accept any interference, including interference
that may cause undesired operation of the device.
The distance between user and products should be no less than 20 cm.
Le pr
é
sent appareil est conforme aux CNR d’Industrie Canada
applicables aux appareils radio exempts de licence. L’exploitation est
autoris
é
e aux deux conditions suivantes:
1. l’appareil ne doit pas produire de brouillage, et
2. l’utilisateur de l’appareil doit accepter tout brouillage
radio
é
lectrique subi, m
ê
me si le brouillage est susceptible d’en
compromettre le fonctionnement.
La distance entre l’utilisateur et de produits ne devrait pas
ê
tre
inf
é
rieure
à
20 cm.
Industry Canada ICES-003 Compliance:CAN ICES-3(B)/NMB-3(B)