Users Manual Part 1

General safety
3
z
Maintain the device by following the instructions in Maintaining the device
on Page 47 to ensure best performance. Otherwise, it might result in
device malfunction or even personal injury.
Caution
z
Only the technical support authorized by the manufacturer or the qualified
and trained personnel can unpack, install, move, and maintain the device.
Incorrect operation might cause inaccurate experiment results or damages
to the device.
z
Do not move the device after the technical support have installed and
debugged the device. Incorrect operation might result in inaccurate
experiment results. If you require to re-position the device, contact the
technical support.
z
Only trained personnel, technicians, or laboratory assistants can operate the
device.
z
Do not operate the device in the presence of flammable or explosive
liquids, vapors or gases. Otherwise, it might result in device malfunction, or
even personal injury.
z
Do not disconnect the power cord when the device is on. Otherwise, it
might result in device malfunction.
z
Do not place tubes or reagent kits on the device. Liquids seeping into the
device might result in device malfunction.
z
Do not reuse the disposable items.
z
Only the peripheral devices and consumables specified by the manufacturer
can be used.
z
If you have maintenance questions that are not mentioned in this manual,
consult the technical support.
z
Only the components provided by the manufacturer can be used for
device maintenance. Unapproved components might damage the device or
degrade performance.
z
The device is verified before delivery. If serious deviation occurs during use,
contact the technical support for calibration.
z
A key is needed to open the fluidics maintenance door after the device is
powered off and it is only accessible to the technical support authorized by
the manufacturer or the qualified and trained personnel, please do not open
the flow stage compartment by force.
z
A screwdriver is needed to open the optics maintenance door after the
device is powered off and the door can be opened only by the technical
support authorized by the manufacturer or the qualified and trained
personnel, please do not open the optics maintenance door by force.