User's Manual

OBID i-scan
®
Installation
ID ISC.ANT800/600-DA
FEIG ELECTRONIC GmbH
Page 39 of 42
M50101-2de-ID-B.doc
E N G L I S H
To maintain the EMC requirements in the USA as per FCC Part 15, two ring cores must be
installed in the cables for the ID ISC.ANT800/600-DA antennas as shown in Fig. 8.
The EMC ring core supplied with the Reader,  28 mm x 20 mm, is installed at the front end of the
cable. Wind the antenna cable at least four times tightly around the ring core. The distance
between the Reader connection and the ring core should be at least 10 cm.
The  41 mm x 15 mm EMC ring core is installed exactly in the middle of the antenna cable. Wind
the coax cable at least 10 times tightly around the ring core. These ring cores are included with the
Reader.
Fig. 8: Installing two ring cores on coaxial cable