User's Manual

OBID i-scan

Installation ID ISC.ANT.MUX
FEIG ELECTRONIC GmbH Page 28 of 37 M30201-1de-ID-B.doc
E N G L I S H
8.5. IN1-2: Reader Connection
The connection to a reader is made using coaxial cable to the SMA jacks IN1 and/or IN2. The
maximum tightening torque of the SMA jacks is 0.45 Nm. The coax cables to the reader terminal
should be routed through the sidewise cable fittings (see Figure 6).
Figure 6: Reader connection
Note:
For optimum read distance, the coax cable should be either less than 50cm or 7.20m in length.
8.6. OUT1-8: Antenna Connection
The antennas are connected using coaxial cable to the SMA jacks OUT1-8. The maximum
tightening torque of the SMA jacks is 0.45 Nm. The connections to the SMA jacks OUT1-4 are
made through the upper cable fittings, and the connections to OUT5-8 through the lower cable
fittings (see Figure 7).
Figure 7: Antenna connections