User's Manual

OBID i-scan

Installation ID ISC.ANT.MUX
FEIG ELECTRONIC GmbH Page 30 of 37 M30201-1de-ID-B.doc
E N G L I S H
9.2. DIP Switch S1
DIP switch S1 can be used to set the various multiplexer modes and addresses. After changing the
DIP switch setting, you must perform a Power-Up Reset by briefly interrupting the supply voltage.
9.2.1. Setting the Modes
The modes are set using DIP switches 1 and 1. Table 3 shows a summary of the settings.
Table 3: Setting modes
DIP switch S1 Address
12345678
-- Reserved
-ON External Trigger Mode
4
ON - HF Communication Control Mode
5
ON ON Reserved
9.2.2. Address Setting in HF Communication Control Mode
The DIP switches can be used to set addresses for HF Communication Control Mode. DIP
switches 3 and 4 are used for setting the corresponding level
6
. Table 4 summarizes the settings for
the levels.
Table 4: Address setting in HF Communication Control Mode
DIP switch S1 Address / Level
12345678
ON --- not used
ON - -ON Level 1
ON -ON- Level 2
ON -ONON Level 3
4
see 10.2. External Trigger Mode
5
see 10.1. HF Communication Control Mode
6
Reference Manual H30701-#e-ID-B.doc