User's Manual

OBID i-scan
®
Installation
ID ISC.ANT800/600-DA
FEIG ELECTRONIC GmbH
Page 28 of 42
M50101-2de-ID-B.doc
E N G L I S H
9 Installation and wiring
9.1 Installing the housing
The ID ISC.ANT800/600-DA antenna is designed for installation on holders made of non-
conducting materials (e.g. plastic or wood) either indoors or outdoors. 6 mounting holes are
provided inside the antenna for attaching (d=5.4 mm, see Fig. 5). We recommend use of a 5 mm
wood screw (DIN 96) or a machine screw (DIN 7985) having a head diameter of at least 10 mm up
to a maximum of 12 mm. The maximum tightening torque for free-turning screws is 2.0 Nm.
If the existing holes are not sufficient, additional holes (d=5.4 mm) can be drilled inside the hatched
area.
The housing cover only needs to be removed when making changes to the factory setting on the
ID ISC.DAT Tuner (see 10.3 Setting the antenna tuner), the tightening torque for the cover screws
when closing up the antenna is 0.2 Nm – 0.25 Nm.
Fig. 5: Installation drawing for ID ISC.ANT800/600-DA (all dimensions in mm)
Note: The antenna must be kept a minimum of 10 cm away from metal parts! Even at
distances of 50 cm or closer a sacrifice in reading range must be anticipated.