Installation Manual

Table Of Contents

OBID i-scan

Installation ID ISC.ANT1690/600-A/-B

FEIG ELECTRONIC GmbH Page 20 of 41 M91200-1e-ID-B.doc

5.2.4 Setting the Antenna Tuner

The jumpers JP1-JP26 of the Dynamic Antenna Tuning board should be set (factory setting) as

follows:

Table 3: Jumper settings for Antenna Tuner

Function Jumper Position

1Ω Q resistor

JP1 open

2Ω Q resistor

JP2 closed

Antenna switch JP3 closed

Capacitor C1 JP 11,12,13,14 open

Capacitor C2 JP 21,22,23,24

JP 25,26

Open

closed

Verify these settings. More on setting the ID ISC.DAT antenna tuner can be found in the

corresponding installation manual (M40401-xde-ID-B).