Installation Manual

OBID i-scan
®
Installation ID ISC.ANT1690/600-A/-B
FEIG ELECTRONIC GmbH Page 22 of 41 M91200-1e-ID-B.doc
Step Action Note
5
Select „Expert Mode“ and
confirm with OK.
Afterwards set the operating power, Transponder Parameters and ISO Host Mode:
Step Action Note
1
Select “Configuration”
2
Air Interface:
“RF-POWER” (here 8W)
„Mulitplexer Enable“
„1 Input (Single Mode)“
„No of Output Channels „
(e.g. 2)
„Antenna Active Time“
100 x 5ms
3
Set by clicking on „Apply“.