Installation Manual

Table Of Contents

OBID i-scan

Installation ID ISC.ANT1690/600-A/-B

FEIG ELECTRONIC GmbH Page 23 of 41 M91200-1e-ID-B.doc

Step Action Note

Transponder:

Configure the parameters as

following:

• „Driver“ – here ISO 15693

• „Anticollision“ – enable

• „No of Timeslots“ –

1 timeslot

• „Data Coding“ – 1 of 4

• „AFI“ – Disabled

Note: National RF regulations may require different

settings. 5.6 Configure the reader in accordance with

national RF regulations

Set by clicking on „Apply“.

Operating Mode:

For antenna tuning the reader

has to be set to „Host Mode“.

Set by clicking on „Apply“.