Installation Manual

OBID i-scan
®
Installation ID ISC.ANT1690/600-A/-B
FEIG ELECTRONIC GmbH Page 25 of 41 M91200-1e-ID-B.doc
5.3 Testing the Gate Antenna
After tuning the gate antenna, you can check for proper function using a reader, the ISOStart
service software and a Transponder. Here the Noise Level and performance of the gate are tested.
5.3.1 Checking the Noise Level
Step Action Note
1
Activate antenna 1 with
command: „Function Unit
Commands - Multiplexer“
Parameter:
„Channel Select“
„Cascade Level = 1“
„Output Channel of Input 1
= 1“
2
Confirm with “Send”
3
Activate “Test and
Measurement”
4
Select „Noise Level“ and
start by clicking on „Start“
5
Normal Noise Level values:
Average:
< 30mV
Difference (Max-Min):
< 20mV
6
Repeat Step 1 to 5 for
every further antenna
If the values are not proper, check the following:
• Are all cables pulled tight and will contact well?
• Are the ring cores installed in the antenna cable?