Installation Manual

Table Of Contents

OBID i-scan

Installation ID ISC.ANT1690/600-A/-B

FEIG ELECTRONIC GmbH Page 33 of 41 M91200-1e-ID-B.doc

5.5 Activating the Automatic Mode

The gate must be used in one of the Automatic Modes (Buffered Read, Notification

or Scan Mode) to get a maximum performance. Otherwise the reading performance

will be significantly reduced.

For more information, see System Manual H60700-2e-ID-B.pdf ID ISC.LRM2000-A/B

In the automatic modes, the tags are read at maximum speed and the information is stored in the

ring buffer of the reader. Data set can be read by the host.

Due to the automatic alarm features at the automatic mode, the reader/gate can run without any

interface connection (Serial, Ethernet).

To activate „Buffered Read Mode“ proceed as follows:

Step Action Note

Select „Configuration“

Operation Mode:

„Mode“ - Buffered Read

Mode

„Data Selector“

-UID

-Antenna No

-Time

-Date

„Filter“

Set Transponder Valid

Time.

(e.g. 55 x 100ms)

Set clicking on „Apply“

Note:

The configuration of the Notification or Scan Mode are similar

To test the function of the Gate in the Buffered Read Mode, the BRM Window of ISOStart or the

BRMDemo program can be used.