Installation Manual

OBID i-scan
®
Installation ID ISC.ANT310/310-A
FEIG ELECTRONIC GmbH Page 6 of 22 M90401-1e-ID-B.doc
3 Installation and Wiring
The antenna has been especially designed for installation with holding devices made of non-
conductive materials (e.g. plastic or wood). It is suitable for both indoor as well as outdoor use. In
order to facilitate the mounting, there are four drill holes (d=5,6 mm) with a spacing of 243 mm at
the inside of the antenna. For attachment, we recommend a wood screw size 5 mm (like DIN 96)
or machine screw (like DIN 7985) with a pen head of minimum ∅ 10 mm till maximum ∅ 12 mm.
The maximum tightening torque of the free turning screws are 2 Nm.
Please keep a minimum distance of 5 cm to all metal parts! Even a distance lower than 30 cm
to metal parts will lead to a reduction of the reading range. See chapter 4.7 Antenna tuning
Figure 1: Installation drawing ID ISC.ANT310/310
All measurements in mm.
For antenna tuning open the housing by removing the four screws at the cover. The maximum
tightening torque for the cover screws is 0,7 Nm – 0,9 Nm.
Antenna opening
(Cover)