Installation Manual

Table Of Contents

OBID i-scan

Installation ID ISC.ANT1700/740-A /-B

FEIG ELECTRONIC GmbH Page 25 of 40 M91201-0e-ID-B.doc

4.3 Testing the Gate Antenna

After tuning the gate antenna, you can check for proper function using a Reader, the ISOStart

service software and a Transponder. Here the Noise Level and performance of the gate are tested.

4.3.1 Checking the Noise Level

Step Action Note

Select „Function Unit

Command“ „Multiplexer“

„Channel Select“ activate

antenna 1.

„Cascade Level = 1“

„Output Channel of Input 1

= 1“

Set by clicking on “Send”

Activate “Test and

Measurement”

Select „Noise Level“ and

start by clicking on „Start“

Normal Noise Level values

at antenna 1:

Average:

< 50mV

Difference (Max-Min):

< 30mV