Installation Manual

OBID i-scan
®
Installation ID ISC.ANT1700/740-A /-B
FEIG ELECTRONIC GmbH Page 26 of 40 M91201-0e-ID-B.doc
Step Action Note
6
Select „Function Unit
Command“ „Multiplexer“
„Channel Select“ activate
antenna 2.
„Cascade Level = 1“
„Output Channel of Input 1
= 2“
7
Set by clicking on „Send“.
8
Repeat step 3 to 5 for
antenna 2.
If the values are not met, check the following:
• Are all cables pulled tight and do they make good contact?
• Were the ring cores installed in the antenna cable?
• Were the cables routed as specified?
• Are other RFID systems installed nearby?
• Are there large metal parts near the antenna (distance < 1.0 m)?
• Are there devices nearby which may emit noise interferences (larger machines or wireless
devices)?
• Are there interferences from the mains?
To determine which devices may be disturbing the gate, briefly disconnect them from the mains.