User's Manual

IDENTIFICATION

ID ISC.ANT1710/690 Crystal

Gate Wave -A/-B

Page 45 of 80

7.6.3 Reader Setting for Alarm Indicators

The ISOStart software can be used to set the Reader configuration so that the output 2 X6-1/-2

opens or closes or the LED´s get a command when a Transponder is read.

Step

Action

Note

Start ISOStart Software

Select “Configuration” and

click on “Read” to read the

complete configuration.

Operating Mode

Select Buffered Read Mode.

Digital IO:

Output Idle Mode: OFF

Idle Flash Mode: 1Hz

Setting Time:

with „Setting Time“ set

time of output 2 for alarm

duration.

(10 means 1 second)

(e.g. 10 x 100ms)

Assign Output 2 to antenna

1+2. „True“ means: Output 2

will be active if the reader

reads a valid transponder.

Set by clicking on „Apply“.

Peripheral Device

LED Controller:

Setting Time:

„Setting Time“ set the dura-

tion time for the alarm.

(10 means 1 second)

(e.g. 10 x 100ms)

Assign

LED Bus Address 11 to