User's Manual

IDENTIFICATION
ID ISC.ANT1710/690 Crystal
Gate Wave -A/-B
Page 49 of 80
7.8 Automatic Bus addressing
The automatic bus addressing should be done after setup, configuring and tuning the gate anten-
na.
The automatic bus addressing will be done after the following conditions:
Step
Action
Note
1
Send a command
“System Reset”
Mode 0x10 Bus Address
In one of the automatic
modes.
2
Changing the operation
Mode from ISO-Host to
Buffered Read or
Notification Mode
3
Changing the number of
output channels of the
multiplexer if reader is in
one of the automatic
modes.
After the automatic bus addressing the right addressing will be signalized by the LED of the
antennas
 Only LED installed. LED will switched on “Red” at the corresponding antenna.
(Should be antenna number 2,3,5,7)
 LED and GPC installed. LED will flash “RED” at the corresponding antenna. (Should be an-
tenna number 1,4,6) 2.GPC must be installed in antenna No.4 and 3.GPC in antenna
No.6 otherwise the autonmatic Bus addressing will fail !
 Here it also could be check if antennas are connected to the right output of the Mux.