User's Manual

IDENTIFICATION
Installation
ID ISC.ANT1520/700-HPDA/-HPDB
FEIG ELECTRONIC GmbH Page 9 von 92 ID ISC.ANT1520700-HPDA-B
User Manual_M61113-0e-ID-
E.doc
2 Instruction on transportation and shipping of the antennas
The packaging of the antennas has been designed to transport antennas vertically standing on a
pallet to the site of installation.
Attention! The antenna has be transported vertically on the base side on the pallet. A
transporting or storing in the false orientation can cause damaging at the antenna.
In case a vertically positioned transport is not possible, the antenna can be transported lying on the
narrow side. A transporting lying on its wide /flat side of the packaging can cause damage to the
device.
The pallet has to be adapted to the size and the number of antennas. In no case shall the
packaging stand out of the range. An additional protection of the edges of the pallet is recom-
mended.
The packaging mustn’t be moist at all times. When transporting overseas by ship or plane, the
packaging has to be protected against get damp at any time.
Temperatures above or below the specified temperature range may damage the antenna and / or
the packaging.
Any mechanical stress on the packaging
is not permitted. Any stacking of packaging, can cause
damaging in the packaging below.
Even after the unpacking of the antennas the face of the antenna plate must be always transported
and stored vertically. A transport in horizontally oriented antenna can deform the antenna plate.