User's Manual

IDENTIFICATION
Installation
ID ISC.ANT1520/700-HPDA/-HPDB
FEIG ELECTRONIC GmbH Page 14 von 92 ID ISC.ANT1520700-HPDA-B
User Manual_M61113-0e-ID-
E.doc
Radar detection zone of a single gate Radar detection zone with two aisles
Radar detection zone with three aisles
Fig. 2: Top view of the detection areas (2-4 antennas, 1-3 gate aisles)
The People Counter board and the Radar detectors are mounted in the base of the antennas. Due
to the radar beam can pervade the plastic housing of the antenna, no openings a necessary.
The Connection between reader and people counter takes place through the RS485 Interface of
the reader, inside the antenna.
There is no need of a direct connection from the GPC to the Host. All commands from the Host to
the People Counters are embedded in the Pickyback command of the reader.
Generally, there are two possibilities to get the actual people counter values. Either the Host poll
the People Counter periodically or in the Notification Mode of the reader, the reader send a notifi-
cation protocol at every change.
In ISO Host or Buffered Read Mode, the host poll the GPC by sending protocols. Only, in the Noti-
fication Mode, the reader poll the counter values, automatically, and send data according the read-
er configuration to the host.
See also System Manual H01011-0e-ID-B.DOC
Counter 1 | Counter 2
In | Out
Cnt. 1 | Cnt. 2
In | Out
Cnt. 3 | Cnt. 4
In | Out
Cnt. 1 | Cnt. 2
In | Out
Cnt. 3 | Cnt. 4
In | Out
Cnt. 5 | Cnt. 6
In | Out