User's Manual

IDENTIFICATION
Installation
ID ISC.ANT1520/700-HPDA/-HPDB
FEIG ELECTRONIC GmbH Page 41 von 92 ID ISC.ANT1520700-HPDA-B
User Manual_M61113-0e-ID-
E.doc
Afterwards set the operating power, Transponder Parameters and ISO Host Mode:
Step Action Note
1
Select “Configuration”
2
Air Interface:
“Output -Power” = 4W
„Multiplexer Enable“
„1 Input (Single Mode)“
„No of Output Channels „
(4 = one aisle)
(6 = two aisles)
(8 = three aisles)
„Antenna Active Time“
100 x 5ms
“Receiver Channel” Upper
and Lower Sideband
3
Set by clicking on „Apply“.
4
Transponder:
Configure the parameters as
following:
• „Driver“ – here ISO 15693
• „Anticollision“ – enable
• „No of Timeslots“ –
1 timeslot
• „Data Coding“ – 1 of 4
• „AFI“ – Disabled
Note: National RF regulations may require different
settings. 7
Configure the reader in accordance with
national RF regulations
5
Set by clicking on „Apply“.